Comments - Siemens Sinumerik 802D sl Programming Manual

04.07
Table 1-2
Bit8 = 1
F thread pitch
C chamfer
R radius, G10 toolcorr
I, J, K interpolation parameters
G04 X or U
A contour angle
G76, G78 thread drilling cycles
$MC_EXTERN_FUNCTION_MASK
Bit8 = 0 F feedrate like G94, G95
Bit8 = 1 F thread pitch
G84, G88 thread drilling cycles
$MC_EXTERN_FUNCTION_MASK
Bit9 = 0 G95 F
Bit8 = 1 G95 F
1.1.8

Comments

In ISO dialect mode, round brackets are interpreted as comment characters.
In Siemens mode, ";" is interpreted as a comment. To simplify matters, ";" is also
interpreted as a comment in ISO dialect model.
If the comment start character "(" is used again within a comment, the comment
will not be terminated until all open brackets have been closed again.
Example:
N5 (comment) X100 Y100
N10 (comment(comment)) X100 Y100
N15 (comment(comment) X100) Y100
In blocks N5 and N10 X100 Y100 is executed, in block N15 only Y100, as the first
bracket is closed only after X100. Everything up to this position is interpreted as a
comment.
© SIEMENS AG 2007 All rights reserved
SINUMERIK 802D sl/840D sl840D/840Di sl/840Di/810D ISO Turning - - 04.07 Edition
Different conversion factors for IS-B and IS-C
Address
Programming Basics
1.1 Introductory explanations
Unit IS-B
mm 0.0001 0.0001
inch 0.00000 0.00000
1 1
mm 0.0001 0.0001
inch 0.00000 0.00000
1 1
mm 0.001 0.0001
inch 0.0001 0.00001
mm 0.001 0.0001
inch 0.0001 0.00001
mm 0.001 0.0001
inch 0.0001 0.00001
0.001 0.001
0.001 0.0001
mm 0.01 0.01
inch 0.0001 0.0001
mm 0.0001 0.0001
inch 0.00000 0.00000
1 1
IS-C
1-15