HP Designjet 3D Service Manual page 388

1 1. Next measure and record the distance from the outside edges of circle A
12. Next measure and record the distance from the outside edges of circle B
13. Add the lengths derived from steps 1 1 and 12 (A-B and B-C) and then
14. Measure and record the distance from the outside edges of circles C
-372
Figure 375: Measuring diameter of B
and B, see Figure 376
Figure 376: Measuring distance from outside edges of A and B
and C, see Figure 377
Figure 377: Measuring distance from outside edges of B and C
subtract the width of circle B. Record this total as "Front"
and F. Ensure the caliper is not seated on the small bump of circle C.
See Figure 378