HP Designjet 3D Service Manual page 303

Figure 253: Left side Y belt retaining clip mounting screw locations
Remove the outer
mounting screws
Loosen, but do not
remove the inner
mounting screws
5
20. Using a ⁄ " box wrench, remove the outer Y belt retaining clip mount-
16
ing screws from the right side. See
5
21. Using a ⁄ " box wrench, loosen, but do not remove, the inner Y belt
16
retaining clip mounting screws from the right side. See
22. Pull the right side Y belt out from the retaining clip.
Figure 254: Right side Y belt retaining clip mounting screw locations
Remove the outer
mounting screws
Loosen, but do not
remove the inner
mounting screws
23. Move the translator to the rear of the printer.
5
24. Using a ⁄ " nut driver, remove the right side X guide rod mounting
16
screws. See Figure 255.
Figure 254.
Figure 254.
-287