5/12VDC Power Supply
Required Tools
5
•
⁄
" nut driver or standard screwdriver.
16
•
Phillips screwdriver
Hardware
3
•
10-32 x
⁄
" slotted screws (x3)
8
1
•
6-32 x
⁄
" Phillips pan head screws (x3)
4
Removing the 5/12VDC power supply
1. Remove the top panel. See
2. Remove the side panels. See
3. Remove the electronics bay. See
page 175
5
4. Using a
⁄
" nut driver or standard screwdriver, remove the 3 rear elec-
16
tronics bay mounting screws. See
Figure 125: Rear electronics bay mounting screw locations
Remove the 3
mounting screws
5. Open the rear panel of the electronics bay.
6. Touch the metal plate of the electronics bay cover to discharge any static
electricity.
7. Disconnect the J2 spade connector by lifting up on the connector. See
Figure 126.
"Removing the top panel" on page 161
"Removing the side panels" on page 162
"Removing the electronics bay" on
Figure 125.
-205