Program *44-3 Incoming Digit Translation (Tie Lines) - Toshiba Strata DK40 Programming Manual

Program *44-3 Incoming Digit Translation (Tie Lines)

Program *44-3
Incoming Digit Translation (Tie Lines)
Program Type:
Initialised Default:
(QWHU 3URJ 0RGH 0 6SNU
Enter 1 - 5
Enter one of the five translations
that can be programmed in
31
32
33
34
35
Note By Pressing "Key 1" = I/P Don't Care
"Key 2" = I/P Don't Care
If Key 1 is used to I/P X2 then translation will be performed on the first digit X1 only
If Key 2 is used to I/P X2 then translation is performed on the first digit X1, but the digit
X2 is deleted from the incoming number
Program *44-3 Overview
Enables the system to translate the first two digits it receives. Up to a maximum of five
different translations can be programmed.
Example: If in Program 44-31 the data entered was 60 200, this would allow the system on
receipt of the digits 60, to translate them and actually dial 200.
Strata DK40 Programming Manual Spring 1999
Toll Restriction
Initialised Data is Blank
7 7 +ROG 6SNU 6
*
Enter up to two digits that must be
translated
Number to be translated
X1 X2
;4 ;5 <4 <5 <6 +ROG 0
Translation
Y1 Y2
System & Station
6SNU & & +ROG 0 6SNU &
Enter up to three digits that X1 and X2 must
be translated to
Y3
3-105
& +ROG