Siemens LOGO! CMR2040 Operating Instructions Manual page 58

Configuration (WBM)
5.2 General functions of the WBM
Incorrect entries in the configuration
In many input boxes of the WBM, the content is checked for missing content or consistency
when you save. Boxes with detected errors or illegal characters are marked with a red
border.
Figure 5-1
With some incorrect entries an additional message is also displayed. The settings are only
applied after the error has been corrected.
Adding, changing and deleting ("Users / groups", "Monitoring")
On the pages of these two parameter groups, you can create new elements and delete
existing ones. Elements are:
Users, recipient groups, message texts, signals, events, actions, assignments
The already configured elements are shown at the top of the page in a table.
● Add
To create a new element click the "Add" button.
An empty input box id displayed where you enter the name of the new element.
Then configure the parameters of the element.
● Change
Select an element in the table on the relevant page and make your changes in the
parameter boxes at the bottom.
● Delete
You can only delete elements that are not used. If for example a text for a message, a
user in a recipient group or a signal in an event, is used you cannot delete the element.
In the table, select the row with the element you want to delete and click the "Delete"
button.
A prompt for confirmation appears.
If you confirm this by clicking the "Delete" button the selected element is deleted and
removed from the list.
Saving
Confirm all your entries by clicking the "Apply" button. Your settings are then adopted by the
device. With some parameters this can take a few seconds. If you make changes to the
mobile wireless configuration this can also take several minutes.
58
Example of an input box with a detected incorrect entry
LOGO! CMR2020,
Operating Instructions, 10/2016, C79000-G8976-C356-03
LOGO! CMR2040