Gee12 (Nor For U.s.), Gee16 (Not For U.s.), Gee50 (Not For U.s.) - Siemens HiPath 3000 Service Manual

3.4.9

GEE12 (nor for U.S.), GEE16 (not for U.S.), GEE50 (not for U.S.)

Introduction
Each of the modules listed below supports four call-metering receiving units for recording and
preprocessing call charge pulses in HiPath 3550 and HiPath 3350.
Table 3-161 GEE12/GEE16/GEE50 (Not for U.S.) Modules
Module Frequency
GEE 12 12 kHz
GEE 16 16 kHz
GEE 50 50 Hz
The call charge detection channel is looped in the trunk and then routed to the TLA
Interfaces
to the TLA
To CO
LS
Figure 3-148 GEE12, GEE16, GEE50 (Not for U.S.) - Interfaces (S30817-Q951-Axxx)
P31003-H3550-S403-4-7620, 02/05
HiPath 3000 V5.0, HiPath 5000 V5.0, Service Manual
also for Silent Reversal
1
X3
10
1
GEE module
X4
8
Remarks
CB side
1 10
X5
Board side
Boards for HiPath 3000
X1
X2
boards.fm
Options
3-337