Starting The Utility - Hitachi Compute Blade 500 Series User Manual

Starting the utility

This section describes how to start the LSI MegaRAID HITACHI SAS 3004 iMR
ROMB Configuration Utility.
1 Start the remote console, and then power on the server blade.
.
Click Power > Power On in the tool bar of the remote console.
2 When <F1>Setup is shown during the server blade startup, press F1.
.
3 UEFI setup menu starts up and the System Configuration and Boot
.
Management window appears.
Note: When the OS has started before pressing the key, shut down the
OS and restart the server blade. See the documents attached to your OS
for shutting down because a specific procedure may be required for
shutting down some OS, such as Windows.
4 Select System Settings on the System Configuration and Boot
.
Management window, and press Enter.
5 When System Settings menu appears, select Storage and press Enter.
.
6 When Storage menu appears, select LSI MegaRAID HITACHI SAS
.
3004 iMR ROMB Configuration Utility and press Enter.
Tip: If an SMP configuration is used, a maximum of four RAID controllers
are recognized. In this case, select a target RAID controller based on the
information of [Bus xx] under [PCI Function Address:] that is displayed on
the right side of the window when you select [LSI MegaRAID <HITACHI
SAS 3004 iMR ROMB> Configuration Utility].
SAS 3004 iMR ROMB Configuration Utility
Hitachi Compute Blade 500 Series EFI User's Guide
5-7