Samsung iDCS 500 Programming Manual page 414

iDCS 500
TECHNICAL MANUAL
ALM
ALARM
CODE
MJD17 RAM Error
MJD18 E1 Restart
MJD19 PRI Restart
MJD20 BRI Restart
MJD21 PCM Loss
MJD22 PCM Recovery
MNF01 Card Out
MNF02 Card In
MNF03 IPC Error
MNF04 Trunk Fault
MNF05 Trunk Recovery
MNF06 Trunk Disconnect
MNF07 Trunk Connect
MNF08 SIO TxQ
MMC: 851
DEFINITION
An error has occurred in the TEPRI or BRI card RAM.
Alarm data = Cabinet, Slot (Cx-Syy)
The E1 card has restarted.
Alarm data = Cabinet, Slot (Cx-Syy)
The PRI card has restarted.
Alarm data = Cabinet, Slot (Cx-Syy)
The BRI card has restarted.
Alarm data = Cabinet, Slot (Cx-Syy)
Loss of PCM coding on a digital facility.
Alarm data = Cabinet, Slot (Cx-Syy)
Recovery of PCM coding on a digital facility.
Alarm data = Cabinet, Slot (Cx-Syy)
A circuit card mounted in a universal slot has been removed
from service or is not recognized by the system.
Alarm data = Cabinet, Slot (Cx-Syy)
A circuit card mounted in a universal slot has been removed
from service.
Alarm data = Cabinet, Slot (Cx-Syy)
Inter processor communication error has occurred.
Alarm data = Cabinet, Slot (Cx-Syy)
Out of service trunk detected via loop detect. Internal CODEC
test.
Alarm data = Cabinet, Slot, Port (Cx-Syy-Pzz)
Out of service trunk detected via loop detected as out of service
is now operational.
Alarm data = Cabinet, Slot, Port (Cx-Syy-Pzz)
Out of service trunk detected via seizure of trunk. External
seizure test.
Alarm data = Cabinet, Slot, Port (Cx-Syy-Pzz)
Out of service trunk recovered via seizure of trunk External
seizure test.
Alarm data = Cabinet, Slot, Port (Cx-Syy-Pzz)
SIO Tx Queue full error has occurred in the MCP.
Alarm data = SIO number (SIO:x)
PROGRAMMING
PART 2 AUGUST 2003
HOME
PAGE
Table of
Contents
HELP