Samsung iDCS 500 Programming Manual page 178

iDCS 500
TECHNICAL MANUAL
USE CHANNEL: the number of provisioned ISDN "B" channels on the PRI (range:
1-23)
TIMER: ISDN T200 and T300 series timer values (note: do not change these since
defaults are correct for U.S. operation
CLI TABLE: This refers to the table in MMC 321 that will be used for Calling party
number (the CLI that is sent).
ACTION
1. Press TRSF 430
Display shows
2. Dial first PRI trunk number in PRI card
(e.g.,7030)
OR
Press UP or DOWN key to make selection
and press RIGHT soft key.
3. Press RIGHT soft key and press UP or
DOWN key to make selection.
4. Press RIGHT soft key twice.
Press UP or DOWN key to make selection
(PRI MODE, CH. SELECT, SWH, USE
CHANNEL, or TIMER) and press RIGHT soft
key.
Do not change this setting to NORMAL since
DDI (i.e., DID) is the only valid setting for the
U.S.
5. Press RIGHT soft key three times and press
UP key.
6. Press RIGHT soft key and press UP key to
make selection.
7. Press RIGHT soft key twice and press UP
key.
MMC: 430
[7001] PRI OPTION
ANY CHANNEL:YES
[7030] PRI OPTION
ANY CHANNEL:YES
[7030] PRI OPTION
ANY CHANNEL:NO
[7030] PRI OPTION
PRI MODE:DDI
[7030] PRI OPTION
CH. SELECT:HIGH
[7030] PRI OPTION
CH. SELECT:LOW
[7030] PRI OPTION
SWH:NI_2
PROGRAMMING
PART 2 AUGUST 2003
DISPLAY
HOME
PAGE
Table of
Contents
HELP