Rs-232 Serial Management Port - Hitachi 3080 G2 Hardware Reference Manual

Figure 5-17 Management interface ports on rear panel - models 3080 and
Item
1
2
3

RS-232 serial management port

The server has one RS-232 connection port, located on the rear panel of the
server. This serial port is intended to be used during system setup. The serial
port is not intended as a permanent management connection. This port
should not be used as the primary management interface for the server. The
primary management interface to the server is through the Web Manager GUI
or through server's command line interface (CLI), which can be accessed
through the network.
Any VT100 terminal emulation interface can be used to access to the CLI so
that you can perform management or configuration functions. Connect the
terminal to the serial port on the rear panel of the server, then set the host
settings to the values shown in the following table to ensure proper
communication between the terminal and the server.
Terminal
Connection
Emulation
Baud rate
Data bits
Stop bits
Hitachi NAS Platform 3080/3090 G2 Hardware Reference Guide
Description
Serial management port (RS-232 DB-9 connector)
Ethernet management port 0 for customer facing management (RJ45 connector)
Ethernet management port 1 for private management (RJ45 connector)
Table 5-17 Host setting values
Requirement
Crossover (null modem) cable
VT100
115,200 Bps
8
1
Hitachi NAS Platform server components
3090
57