Toro ProPass 200 Service Manual page 95

Removal (Fig. 12)
1. Position machine on a level surface. If ProPass is at-
tached to tow vehicle, apply tow vehicle parking brake,
stop engine and remove key from the ignition switch.
Chock wheels to prevent ProPass machine from mov-
ing.
2. Remove left side conveyor frame and the floor con-
veyor belt (see Floor Conveyor Belt in this section).
3. If drive roller is to be removed:
A. Remove drive chain and sprocket from drive
roller (see Floor Motor Drive in this section).
B. On right side conveyor frame, loosen bearing
locking collar on drive roller shaft (see Drive Roller
Bearings in this section).
C. Slide drive roller from bearing and remove from
machine.
4. If idler roller is to be removed:
A. On right side conveyor frame, loosen bearing
locking collar on idler roller shaft (see Idler Roller
Bearings in this section).
B. Slide idler roller from bearing and remove from
machine.
ProPass 200
Installation (Fig. 12)
IMPORTANT: During roller installation, do not lock
bearing collars on idler and roller shafts until after
both sides of conveyor frame are assembled and
rollers are centered in the frame.
1. Insert removed roller into bearing on right side con-
veyor frame. Do not lock bearing collar or install set
screw in collar at this time.
2. Install the floor conveyor belt and left side conveyor
frame to machine (see Floor Conveyor Belt in this sec-
tion). During assembly, make sure to center the rollers
in the frame, to lock the bearing collars and to install set
screws in collars on both sides of idler and drive roller
bearings.
3. If drive roller was removed from right side conveyor
frame, install sprocket and drive chain to drive roller (see
Floor Motor Drive in this section).
4. Grease all four (4) bearings after installation is com-
plete.
Page 5 - - 13 Chassis