Information - Toro ProPass 200 Service Manual

Solenoid Valve Assembly (Machines with Standard Hydraulic Controls)
Two (2) identical solenoid valve assemblies are used on
machines with standard hydraulic controls. When ener-
gized, these solenoid valves allow hydraulic flow to en-
gage the floor and rear option (twin spinner or conveyor)
motors.
NOTE: See Hydraulic Control (Machines with Standard
Hydraulic Controls) in this section for information on re-
moving the solenoid valve assembly from the machine.
CAUTION
Before continuing further, read and become fa-
miliar with General Precautions for Removing
and Installing Hydraulic System Components in
this section.
For cartridge valve service procedures, see Hydraulic
Control Manifold (Machines with Wireless Control Mod-
els) in this section. Refer to Figure 32 for cartridge valve
and solenoid coil nut installation torque.
NOTE: See Hydraulic Solenoid Valve Coils in Chapter
4 -- Electrical System for information on testing the
solenoid coils.
ProPass 200
1
1. Floor solenoid valve
2
3
25 ft- -lb
(34 N- -m)
1. Nut
2. Solenoid coil
3. Cartridge valve
Page 3 - - 31
Figure 31
2. Option solenoid valve
1
60 in- -lb
(6.7 N- -m)
4
5
Figure 32
4. Seal kit
5. Manifold
Hydraulic System
2