Error Messages Common To All Commands - Fujitsu XG0224 User Manual

XG Series User's Guide
2.2.2

Error Messages Common to All Commands

The table below lists error messages common to all commands and displayed when autocompleting or executing
commands.
Note that the argument position shown in these error messages indicates the place of the erroneous argument, counted from
the command name as "1."
Common error message
<ERROR> Command name: Unknown command
<ERROR> Command name: Operation not permitted
<ERROR>: 0: missing argument
<ERROR>: 0: too many argument(s)
<ERROR>: Argument position: format error
<ERROR>: Argument position: value out of range
<ERROR>: Argument position: lack of table
<ERROR>: Argument position: no such table
<ERROR>: Argument position: duplicate value
<ERROR>: Argument position: fail to request
<ERROR>: Argument position: unique password
<ERROR>: detected HARD ERROR, cannot execute
An unknown command.
Cannot be executed in the current use mode.
Cannot be executed with the current privilege class.
Execution of this command is not permitted.
The argument specification is insufficient.
The argument specification is excessive.
The argument syntax is not correct.
Unknown command for configuration hierarchy.
The argument value is out of the valid range (too small, too large,
too long, etc.).
The number of arguments has reached the defined upper limit.
Specified definition cannot be found.
Already defined.
Could not execute the command.
Not a unique password.
Cannot be changed from the unique format.
Cannot execute the command due to a hardware error.
53
Chapter 2 Using the CLI
Meaning
Using the CLI