Yamaha 2007 XP500 Service Manual page 87

1. Brake hose holder 1
2. Front brake hose
3. Speed sensor
4. Plastic holder
5. Brake hose holder 2
6. Speed sensor lead
7. Stay 1
8. Brake hose holder 3
9. Rear brake hose 1
A. Fasten the speed sensor lead along the inside
of the brake hose.
B. 50 – 60 mm (1.97 – 2.36 in)
C. Turn the handlebar completely to the right, and
then fasten the brake hose and speed sensor
lead together with the plastic holder.
D. Install the stopper to lower bracket projection.
E. Fasten the speed sensor lead along the outside
of the brake hose.
F. 30 – 40 mm (1.18 – 1.57 in)
G. Make sure that brake pipe touches the projec-
tion.
H. Make sure that the slot in the speed sensor fits
stopper on the outer tube.
I. Make sure that the stopper touches the outer
tube stay.
J. Pass the speed sensor lead between the brake
hose and front fork.
K. Fasten the speed sensor lead to the center of
brake hose holder.
L. Install the hose holder to the innermost
securely.
M. Engage the hose holder rib more than 3 notch.
Face the hose holder projection to the back.
N. Make sure that the white paint on the brake
hose faces to back (right side only).
O. Install the stopper to the stay 1.
P. Fasten the front brake hose and rear brake
hose with a hose holder.
Q. Make sure that the brake hose joint touches the
projection of the outer tube.
R. Make sure that the brake hose holder touches
the projection of the outer tube.
S. 107 mm (4.21 in)
T. Clamp the speed sensor lead with a plastic
holder at the marking center.
2-50
CABLE ROUTING