Epson Artisan 700 Service Manual page 217

Epson Artisan 700/Epson Stylus Photo PX700W/TX700W
• The EJ Frame Assy must be lowered most.
80 column side
Confirm they are set here.
Figure 5-35. Position of EJ Frame Assy
• Check that the PG cams; located on both the left side and the right side of the
Carriage Shaft and the CR guide plate, are in the PG-position.
Left side
Right side
Figure 5-36. PG position when adjusting
ADJUSTMENT
Adjustment procedure
1. Move the carriage to the home position.
0 column side
2. Loosen all the screws the secure each parallelism adjustment bushing.
3. Attach the parallelism adjustment jigs to the printer mechanism.
Place the rear of Jig on
( Fig. 5-36 ) Carriage Shaft.
Location of the bits of dial gauge (A) (B)
Adjustment without Using Adjustment Program
Location of the bits of dial gauge (C) (D)
D
Place Jig aligning the bits with the ribs shown above.
B
A
B
A
Place Jig aligning the bits with the ribs shown above.
Figure 5-37. Installing the parallelism adjustment jigs
Revision C
( Fig. 5-34 )
C
D
C
Place the front of Jig on CR
Guide Plate.
237
Confidential