System Fans - Bosch DIVAR IP 6000 1U Installation Manual

DIVAR IP 6000 1U
2.
3.
3.7

System fans

The system fans provide cooling for the chassis. These fans circulate air through the chassis as
a means of lowering the chassis internal temperature.
Warning!
The fans might still be turning when you remove the fan assembly from the chassis. Keep
!
fingers, screwdrivers, and other objects away from the openings in the fan assembly's
housing.
To add a system fan
1.
2.
3.
4.
5.
The chassis includes four pre-installed fans. One or two extra slots are available so that.
additional fans may be added.
Bosch Sicherheitssysteme GmbH
Do not operate the system without drives or drive trays in the drive bays. Use only
recommended material.
Make sure no wires or foreign objects obstruct air flow through the chassis. Pull all
excess cabling out of the airflow path or use shorter cables. The control panel LEDs
inform you about system status.
Turn off the power to the system and unplug the system from the outlet.
Remove the dummy fan from the fan tray.
Place the new fan into the vacant space in the housing. Make sure the arrows on the top
of the fan (indicating air direction) point in the same direction as the arrows on the other
fans.
Connect the fan wires to the fan headers on the server board.
Power up the system and make sure that the fan is working properly before replacing the
chassis cover.
Installation manual
Chassis setup and maintenance | en
2014.01 | V2 | DOC
19