Drive Carrier Leds; Power Supply Leds And Overheat Indicators - Bosch DIVAR IP 6000 1U Installation Manual

12 en | System overview
–
–
–
–
2.3.3

Drive carrier LEDs

Your chassis uses SAS/SATA.
SAS/SATA drives
Each SAS/SATA drive carrier has two LEDs.
–
–
2.3.4

Power supply LEDs and overheat indicators

This chassis provides several options which may include hot-swappable, cold-swappable, and
redundant power supplies. Some power supplies include an LED in the rear with the following
definitions:
450 W and 650 W power supplies
450 W and 650 W power supply LEDs
Solid green
Solid amber
Blinking amber
All other power supplies
All other power supply LEDs
Solid green
Solid amber
2014.01 | V2 | DOC
NiC2: A flashing LED indicates network activity on GLAN2.
NIC1: A flashing LED indicates network activity on GLAN1.
HDD: A flashing LED indicates IDE channel activity in the SAS/SATA drive, SCSI
drive, and/or DVD-ROM drive activity.
Power: Indicates power is being supplied to the system's power supply units.
This LED should normally be illuminated when the system is operating.
Green: Each Serial ATA drive carrier has a green LED. When illuminated, this green LED
(on the front of the SATA drive carrier) indicates drive activity. A connection to the SATA
backplane enables this LED to blink on and off when that particular drive is being
accessed.
Red: The red LED indicates a SAS/SATA drive failure. If one of the SAS/SATA drives fail,
you should be notified by your system management software.
Power supply is on.
The power supply is plugged in and turned off, or the
system is off but in an abnormal state.
Power supply temperature has reached to 63" C. The
system automatically turns off when the power supply
temperature reaches 70" C and restarts when the
power supply temperature is below 60" C.
Power supply is on.
The power supply is plugged in and turned off, or the
system is off but in an abnormal state.
Installation manual
DIVAR IP 6000 1U
Bosch Sicherheitssysteme GmbH