Installing The Motherboard; Installing The Air Shroud - Bosch DIVAR IP 6000 1U Installation Manual

18 en | Chassis setup and maintenance
3.5

Installing the motherboard

Motherboard problems will be handled by trained support people only.
3.6

Installing the air shroud

Air shrouds concentrate airflow to maximize fan efficiency. The air shroud does not require
screws to set up.
Air shroud with the Optional Flap Removed
To install the air shroud:
1.
2.
3.
4.
To check the air flow:
1.
2014.01 | V2 | DOC
Remove the chassis cover.
If your motherboard uses between 9 and 16 DIMMS, skip this step. If your motherboard
uses 8 DIMMS, you must remove the optional flap. To do so:
– With the fan side facing you, hold the air shroud with your left hand on the main
shroud component and right hand on the optional flap.
– Gently twist with your right hand by lifting the fan side and lowering the other end of
the optional flap.
Place the air shroud in your chassis with the fan side touching the edge of the fans.
Replace the chassis cover.
Make sure there are no objects to obstruct airflow in and out of the chassis. In addition, if
you are using a front bezel, make sure the bezel's filter is replaced periodically.
Installation manual
DIVAR IP 6000 1U
Bosch Sicherheitssysteme GmbH