DVSR xU User Manual
2.
DVSR xU installation
This section describes how to connect the DVSR xU unit.
Connecting the devices
Figure 2 shows the back panel connections and describes each connector. There are variations
between the different model types.
Figure 2: DVSR16 xU back panel connections
Required connections
A.
Connect up to 16 cameras to the standard BNC video inputs.
Note: If a camera is incorrectly connected to the DVSR xU, the monitor shows a Video Loss message. Check the
connection and reconnect the camera if necessary.
B.
Connect monitor A (main) to the output VIDEO OUT. Connect the audio output () to AUDIO OUT if required. You can
use either analog or VGA output. Both outputs will display the same video information.
Optional connections
C.
Connect a spot monitor (Mon B) to the DVSR xU. Connect the monitor video to VIDEO OUT. Connect the monitor audio
(if used) to AUDIO OUT ().
D.
Connect up to 16 audio signals to the standard BNC audio inputs (315 mV).
E.
For future use.
F.
Connect the VGA display (max. 1024 × 768 @ 60 Hz).
G.
Connect an ATM or optional ProBridge using the supplied RS-232 cable.
H.
Connect the network devices.
I.
Connect the USB mouse (supplied).
J.
Connect the E-SATA for archive and storage expansion.
3