Nokia IP40 User Manual page 108

10
Configuring the Nokia IP40 through Out of Band Management
To configure the modem settings from the IP40 GUI
1. Click Network from the main menu, and select the Modem tab.
The Modem page appears.
2. From the drop-down menu next to Modem type, select Standard or Custom.
In the case of Custom Modem, you can specify additional initializaton string, apart from the
standard initialization string (refer to Step 6).
3. From the drop-down menu next to Dial mode, select Tone or Pulse.
4. Select the port speed in bps from the drop-down menu next to Port Speed.
This speed defines the modem port speed. The values can be 9600, 19200. 38400, 57600,
115200, 230400 or 460800 bps.
5. Check the box next to Answer incoming PPP calls, if you want to answer the incoming PPP
calls.
6. Enter a suitable string next to Initialization String. This string will be used for accessing
additional Modem features.
For example, to disable the modem speakers, enter the initialization string ATM0.
Note
Refer to the user manual of your modem for finding out the suitable init string.
7. Click Apply to save your modem settings.
8. Click on the Test button to verify whether your modem settings are working fine.
Note
You cannot configure all the OOB parameters from the IP40 GUI. The parameters which
cannot be configured from GUI such as address of the OOB interface, destination address
of the OOB interface and set IP header compression have default values. Use the CLI only
to change these values.
108 Nokia IP40 User Guide