Nokia 9000i Service Manual page 220

RAE/RAK–1N
Service Software
7.9 – Checksum ROM
Enabling this choice adds the Checksum ROM test to be included to the
test sequence. The test is performed with default parameters as follows:
Start Physical Address
Start Relative Address
End Physical Address
End Relative Address
The output from the target shows the following:
whether the command was parsed successfully
whether the test was successful
7.10 – Start Testing
Choosing this choice, the automatic test sequence is started using the
enabled tests. These tests can be carried out individually by disabling all
tests except the one required and then selecting 'Start Testing.'
The output from the target shows the following:
whether the tests are O.K. or have failed.
Page 7– 62
Technical Documentation
default:3C00000h
default: 000000h
default:3E00000h
default: 1FFBFFh
Amendment 1 04/97
After Sales