Nokia 9000i Service Manual page 219

After Sales
Technical Documentation
7.5 – Buzzer Test
Enabling this choice adds the Buzzer test to be included to the test
sequence. The test is performed with default parameters as follows:
Frequency default:
Duration default:
Frequency default:
Duration default:
Frequency default:
Duration default:
7.6 – PMI Test
Enabling this choice adds the PMI test to be included to the test
sequence. The test is performed with default parameter. This test requires
user activity; the user must turn the CMT module on/off using the CMT
power switch, or/and the user must open/close the UI.
The default parameters used:
TimeOut default:
The output from the target shows the following:
whether the test was successful
7.7 – RTC Test
Enabling this choice adds the RTC test to be included to the test
sequence. The test is performed with no default parameters.
The output from the target shows the following:
whether the test was successful
7.8 – Serial Test
Enabling this menu adds the Serial test to be included to the test
sequence. The test is performed with default parameters as follows:
Mode default:
Port default:
The output from the target shows the following:
whether the test was successful
Amendment 1 04/97
500 Hz
0.3 s
1000 Hz
0.3 s
1500 Hz
0.3 s
25.0 s
Local loop
COM1
COM2
RAE/RAK–1N
Service Software
Page 7– 61