Table of Contents
Advertisement
Type I (Current setup w/router.
Existing router as DHCP server)
Type II (Current setup w/DSL or
cable modem and no router. The
ISP is the DHCP server)
Type III (No internet connection)
If your setup looks most like Type
I - Follow Instructions & "Special
Instructions for Type I"
If your setup looks most like Type
II - Follow Instructions & "Special
Instructions for Type II"
If your setup looks most like Type
III - Follow Instructions & "Special
Instructions for Type III"
The M-VCI – NETGEAR Router
install procedure is similar
for all types. When a "Special
Instruction" is called out, please
M-VCI – NETGEAR® Router Installation Guide Index | Version 1.0 | April 2011
Getting Started | 4
follow the one pertaining to your
setup type.
The Type III has no internet
connection but uses the
NETGEAR Router to enhance
M-VCI to PC wireless
communication.
Example – Final Setup
Configuration for Type I
This shows the new NETGEAR
pre-configured router installed
into a network (Setup Type I) with
a pre-existing wireless router. No
network changes need to be made
to existing routers or computers.
Do not perform this final set up
until directed to do so. You need
to configure your new NETGEAR
Router first.
Example – Final Setup
Configurations for Types II
& III
Robert Bosch LLC
Advertisement
Table of Contents
