Panasonic KX-UDS124 Administrator's Manual page 151

The pre-provisioning process
Step 1
Connect the SIP-CS to the network, and turn the
power on. The SIP-CS is assigned an IP address by
the DHCP server, and also receives the TFTP
server address from the DHCP server using DHCP
server option 66.
Step 2
The SIP-CS downloads the configuration file for
pre-provisioning from the TFTP server:
tftp://192.168.0.130/KX-UDS124.cfg
Step 3
The URL of the server where the configuration file
for provisioning is stored (provisioning server) is set
to the SIP-CS:
http://provisioning.example.com/Panasonic/
Config{MAC}.cfg
Step 4
When pre-provisioning is complete, the SIP-CS's
LED will flash red, amber and green alternately.
Step 5
When the LED is flashing alternately, turn off the
SIP-CS's power, then turn it back on.
The SIP-CS may restart automatically depending on
the configuration file programming (® see
"OPTION66_REBOOT" in 4.2.5 Provisioning
Settings).
When the SIP-CS is distributed to end users and
started up in real circumstances, provisioning will be
performed correctly.
Note
•
This example describes the case when only one SIP-CS is connected. However, multiple SIP-CSs can
be configured through the same procedure without changing any settings, because the MAC address
is specified by the {MAC} macro.
Document Version 2013-03
3.1.4 Pre-provisioning Setting Example
Power on
TFTP Address
SIP-CS
192.168.0.130
tftp://192.168.0.130/
KX-UDS124.cfg
SIP-CS
http://provisioning.example.com/
Panasonic/Config0080F0123456.cfg
SIP-CS
Alternate flashing
(red, amber and green)
SIP-CS
http://provisioning.example.com/
Panasonic/Config0080F0123456.cfg
Config0080F0123456.cfg
SIP-CS
DHCP Server
Option 66
TFTP Server
KX-UDS124.cfg
Provisioning
Server
Administrator Guide 151