Acer Power 2100 User Manual page 132

A.3.2 Rear View
Figure A-2 Rear Panel
1. Power supply connector connects the CD-ROM drive to the computer's power supply
2. Interface connector connects the CD-ROM drive to the 40-pin interface cable
3. Device configuration jumper. The CD-ROM drive is configured as a master drive, so a jumper is installed on
"MA". To change the setting to slave, remove this jumper.
4. Digital Audio Output offers high quality Audio, through a digital signal from a D/A converter
AcerPower 2100 (V66LT/IDB3-C) User's Guide
132
C a b l e S e l e c t
S l a v e
AUDIO
M a s t e r
Your CD-ROM rear panel may be slightly
different from the one shown above.
IDE INTERFACE
DC INPUT