Command Line Reference
QoS Commands
9-158
rate-limit
This command configures the maximum rate at which the access point
transmits multicast and broadcast traffic. The no version of the command
disables rate-limiting on the radio.
Syntax
rate-limit <rate> <burst>
no rate-limit
rate - The broadcast/multicast rate limit value in packets per second.
•
The no version is disabled for this parameter. Valid values are any
number greater than 0.
•
burst - The broadcast/multicast rate burst value in packets per second.
This value specifies the length of time allowed for a packet burst. Valid
values are any number greater than 0.
Default Setting
Disabled. Rate-limit rate is 50, Rate-limit burst is 75.
Command Mode
Radio Interface Configuration
Example
ProCurve Access Point 530(radio1)# rate-limit 2 5
ProCurve Access Point 530(ratio1)#
Related Commands
beacon-interval (page 9-109)