C A U T I O N
Example
ProCurve Access Point 530# configure
ProCurve Access Point 530(config)# dns secondary 10.1.0.55
ProCurve Access Point 530(config)#
ip address
This command configures the IP address settings for the interface. The no
version of the command clears the statically assigned IP address and network
mask.
Syntax
ip address <ip> [<mask>] | <ip>/<bits> | dhcp
no ip address
•
ip - Specify the static IP address to be used when DHCP is not used.
The no version of the command clears the statically assigned IP
address and network mask.
mask - Specify the static network mask to be used when DHCP is not
•
used. The no version of the command clears the statically assigned IP
address and network mask.
bits - Specify the static network mask in CIDR notation to be used
•
when DHCP is not used. The no version of the command clears the
statically assigned IP address and network mask.
dhcp - Enable the DHCP client on this interface. The no version of the
•
command disables the DHCP client on this interface.
• secondary - Specifies a secondary IP address.
Default Setting
IP address: 192.168.1.1
Netmask: 255.255.255.0
Command Mode
Interface Configuration (Ethernet)
Command Usage
In order to disable the DHCP and assign a Static IP address, you must have a
serial port connection to the AP. Otherwise, you will lose connectivity during
the process of assigning a new static IP address.
Command Line Reference
Ethernet Interface Commands
9-95