Running An Internal Test - HP StorageWorks 3800ux User Manual

Navigation
Table 7: Information logs (Continued)

Running an internal test

READY > ADMIN* >TEST*
This section describes self-diagnostic tests that are available on the jukebox.
1. With READY displaying on the control panel, press NEXT until ADMIN*
2. Enter the administration password (see
3. TEST* displays. Press ENTER.
4. Press NEXT until the name of the test you want to run displays and then press
46
Log name
*
—
MICROMOVE 6
#
*MICROMOVE ER #
TOP or BOTTOM
PICKER
NORTH or SOUTH
THUMB
Caution: Diagnostic tests should be run only by an authorized service
representative. Descriptions of the self-diagnostic tests are included in this
for information purposes only
manual
internal diagnostic tests can corrupt your file system. In some rare instances,
your service representative may request that you run specific tests to provide
information before they come to your site, or you may receive a control panel
message to run a specific test.
displays.
password" on page 44).
ENTER to start the test.
Sixth jukebox micro-move for the original move
command issued prior to the failure. (This is the
last to be logged.)
Micro-move error that occurred.
Displays either TOP or BOTTOM indicating
which side of the disk transport mechanism was
active at the time of the error.
Displays either NORTH or SOUTH indicating
which thumb on the transport mechanism was
active at the time of the error.
. If not properly completed, some of the
"Entering the administration menu
HP StorageWorks 3800ux/7100ux Optical Jukebox User's Guide
Description