Table of Contents
Advertisement
Main Specifications
Hardware
Even though the server is set up as a DHCP client, no IP
address appears on the server's LCD display.
• Verify whether the network cable is connected correctly.
• Verify whether the front LAN LED and the rear LINK LED are lit.
• Verify whether the DHCP server is active on the network.
• Verify whether any IP addresses are available for the DHCP server to assign.
Cannot backup to the library unit
• Check the ARCserve settings. To set "ARCserve", make sure you access the
"ARCserve" page from "Backup & Restore" under "Backup & Restore" in the
BSV-M1 Administration Menu. For more information, refer to the ARCserve
Online Manual. Use "Application Manual" in the "Online Document Menu"
to view the Online Manual.
The server shuts down automatically
• Check whether the shutdown schedule is set to "Disable" in "Shutdown" of
the BSV-M1 Administration Menu.
Others
• If you are unable to rectify problems by the methods described above, or the
system becomes unstable, you can reset the system manually. For details,
refer to "System Restore" (page 48) in "Appendix".
Hard disk drive
20GB (BSV-M1/20) (1)
LCD panel
20 characters 2 rows
LED lamps
5 lamps
External connectors
Ultra 2
Wide LVD SCSI (1)
Ethernet
10Base-T/100Base-TX (RJ-45) (1)
Operating environment
Temperature: 5 to 35°C
Humidity: 20 to 80%
(Avoid condensation)
Rated Voltage AC100-127/200-240V (50/60Hz)
Rated Current
1.5A
External dimension
430(W) 44(H) 374(D)
16.9(W) 1.7(H) 14.7(D)
Weight
About 6kg
About 13.2lb.
Notice: Specifications and outward appearance of BSV-M1 are subject to
change without notice.
52
Appendix
Advertisement
Table of Contents
