Panasonic EASA-PHONE KX-T123210 Installation Manual page 144

To transfer a call after the outside party answers.
Press
TRANSFER
Press CO
Dial phone Announce
Hang up or
number
and wait press
for an
SP-PHONE
answer
To transfer a call without announcing to the outside party.
Press Press CO
Dial phone Hang up or
TRANSFER
number
GHONE
Description
Outside or intercom calls may be transferred to
any outside line manually.
This feature is required to be set beforehand in
the KX-Tl23210.
0 Even if you dial the incorrect phone number
Conditions
to which the call is transferred, it is possible
to redial the correct phone number after
pressing the FLASH button.
For programming, see page 3-71.
0
Operation
1.
You are engaged in a call (outside or
intercom).
2. Press the TRANSFER button.
3. Press the CO button to which the call is
transferred.
4. Dial the phone number to which the call is
transferred.
0
5. For Unscreened call transfer, replace the
handset back on hook or press the
SP-PHONE button.
For Screened call transfer, wait for new party
to answer and announce call, then replace
the handset back on hook or press the
SP- PHON E button.
To change
the party to whom a call is
transferred before hanging up
Press the CO button whose indicator is flashing
slowly to retrieve the call, then repeat the
procedure of Call Transfer.
4-19
If outside call is transferred to any outside
line, the KX-T123210 will disconnect the call
from the line after 10 minutes. For changing
the time, see "CO to CO Duration Time
Limit" on page 3-30.
3 beeps tone will be heard every 5 seconds
for 15 seconds before the call is disconnected
from the line.
If the outside call is transferred to another
outside line through the KX-T123210, the
KX-T123210 may not disconnect both lines
after the calling party hangs up if the calling
parties line (central office exchange) does
not release a CPC (Calling Party Control)
signal to the line.
However the KX-T123210 will disconnect the
line after the time that you have
programmed. (See page 3-30.)
;