3. Creating an HDLM Environment
This example shows how to specify the audit log facility:
# /opt/DynamicLinkManager/bin/dlnkmgr set -audfac local0
3.18.3 Checking the Updated Settings
This chapter describes steps involved in how to check the new settings by using the
command's
dlnkmgr
When you some these settings, you can display information about all of HDLM
function settings. The following is an example of executing the command:
# /opt/DynamicLinkManager/bin/dlnkmgr view -sys -sfunc
HDLM Version
Service Pack Version
Load Balance
Support Cluster
Elog Level
Elog File Size(KB)
Number Of Elog Files
Trace Level
Trace File Size(KB)
Number Of Trace Files
Path Health Checking
Auto Failback
Reservation Status
Intermittent Error Monitor
KAPL01001-I The HDLM command completed normally. Operation name
= view, completion time = yyyy/mm/dd hh:mm:ss
#
After you have set up the collection of audit log data, use the following command to
make sure that the setting has been specified correctly:
# /opt/DynamicLinkManager/bin/dlnkmgr view -sys -audlog
Audit Log
Audit Log Category
Audit Log Facility
KAPL01001-I The HDLM command completed normally. Operation name
= view, completion time =
#
280
operation after the new settings are applied.
set
x.x.x-xx
:
:
: on(extended lio)
:
: 2
: 1000
: 5
: 1
: 2000
: 10
: on(10)
: on(10)
:
: on(2/20)
: on(6)
: all
: local0
yyyy
mm
/
/
dd
hh
mm
ss
:
: