HP D6030A - NetServer - E50 Installation Manual page 7

Chapter 1
Select "Other (Requires Disk provided by a hardware manufacturer)."
When prompted to insert the "Manufacturer-supplied
hardware support disk", insert the E 200 Drivers Diskette #1
(SCSI/LAN) into floppy drive A:.
Select the "HP 2940/78xx SCSI Driver" by pressing Enter.
5. Press S again to install the IDE CD-ROM driver.
6. Press the up arrow key to view more driver selections.
7. Select the "IDE CD-ROM (ATAPI 1.2)/PCI IDE Controller" driver by
pressing enter.
8. Replace the diskette when prompted to do so.
9. Ensure that both the SCSI and CD-ROM drivers are loaded. The
installation will not be successful if these two drivers are not properly
installed. If you have any more mass storage device drivers to install, you
may do so at this time by pressing S. When completed, press the Enter key
to continue.
PHASE 2 – Hard Drive Preparation
1. Press Enter to continue if you are warned about your hard disk containing
more than 1024 cylinders.
2. Depending on the previous state of your hard drive, you may need to press
C to continue with the installation when prompted.
3. Insert the Windows NT CD-ROM when prompted.
4. Read the Licensing Agreement and agree to continue the installation.
5. The Windows NT Server Setup Screen will display the system hardware
and software components. Press Enter if the configuration matches your
computer.
6. The setup then shows a list of hard drives on your server, along with the
partitions proposed on each drive. The default partition on which to install
NT on the first drive (Drive 0) is highlighted. Select C to create a partition
in the unpartitioned space.
7. Enter the appropriate size for your NOS partition. HP recommends
2000MB.
8. Press Enter to Install NT on the New (Unformatted) partition.
9. Select a file system format: FAT (DOS type file system) or NTFS
(Windows type file system - recommended) for this NOS partition.
Microsoft Windows NT 4.0 Server Installation Guide
3