Bridge 802.1D; Bridge 802.1D Information And Port Table - D-Link D-View 5.1 User Manual

D-View 5.1 User's Guide
Below the graph area are message boxes for displaying some information about the
displayed graphs and other system messages. The boxes at the right display the total
count per second for each graph, the current position of the graph marker (in the range
from 0 up to 99; with 0 being the leftmost part and 99 the rightmost part of the graph),
and the system time and date.
The statistics table displays the values of a particular statistics counter. To select a
statistics counter, just click the down-arrow button at the right of this table. A list
appears displaying the following counters: Input Frames, Output Frames, and Discard
Frames. Click the counter you want. The label on this table reflects your choice.
The following describes the displayed values:
Avg displays the average count per second.
Peak displays the peak count per second.
Pk At displays the time when the peak count occurred.
The Rate buttons set the polling time of the management console. Polling time
determines how often the management console polls the device for statistics. A polling
time of 5 seconds for example means that the management console polls the device
every five seconds to retrieve statistics values. These values are then processed and
displayed on the screen. To increase the polling time, click the up-arrow button; to
decrease, click the down-arrow button.
The Dur buttons set the range on the x-axis. Use these buttons to enhance the graph
readability if they appear too wide or too narrow. If the graphs appear too wide, click
the down-arrow button to increase the range on the x-axis. If the graphs appear too
small, click the up-arrow button to decrease the range.
The Pause button pauses device polling.
The Start button resumes device polling.

Bridge 802.1d

Bridge 802.1d Information and Port Table

First some Bridge 802.1D (RFC 1493) MIB Group Definitions:
152