Chapter 9
Determine where to Install HP NetRAID Assistant
HP NetRAID Assistant can be installed on any client running Microsoft
Windows NT, Windows 2000, or Windows 95/98.
HP NetRAID Assistant can be installed on any server running Microsoft
Windows NT or Windows 2000.
Identify the Registration Server/Client
Only one server or client on the network can be identified as the Registration
Server. The Registration Server does not have to be the same server or client that
is running HP NetRAID Assistant.
The HP NetRAID Registration Server utility can be installed on only one server
running Microsoft Windows NT, Windows 2000, or Novell NetWare.
The HP NetRAID Registration Server utility can be installed on only one client
running Microsoft Windows NT, Windows 2000, or Windows 95/98.
HP NetRAID Network Utilities to Install
For each client or server, refer to Table 9-1 to determine which HP NetRAID
utilities to install on it, as indicated by an X in Table 9-1.
All clients and servers should be running HP NetRAID network utilities
upgraded to the versions on the most recent HP Netserver Navigator CD-ROM.
HP NetRAID remote management is now done through NetWare Sockets
for NetWare 4.x and NetWare 5.x. (RPC was previously used under
NetWare 4.x.) Be sure to upgrade all existing HP NetRAID remote
management installations, as well as the HP NetRAID Assistant utility.
All Windows NT, Windows 2000, and Windows 95/98 clients and servers
should be running the versions of the HP NetRAID utilities supplied on
the current HP Netserver Navigator CD-ROM. If they are not running the
same versions, some clients and servers may not be able to communicate
with each other.
110
Managing Servers Over the Network