Uninstalling Epson Status Monitor 2; From Windows 95, 98, And Nt 4.0 - Epson C823642 - Enet Print Server Type B Multi Protocol 10/100BTX Administrator's Manual

Uninstalling EPSON Status Monitor 2

You can remove EPSON Status Monitor 2 from your computer by
following the instructions for your operating system below.
c
Caution:
Quit other programs such as virus check programs before removing
EPSON Status Monitor 2.
Note for Windows 95:
If EPSON TCP/IP printing is enabled, disable it as described on
page 11-5.
Note for Windows NT 3.51 and 4.0:
You need to log on as the Administrator.
When you try to uninstall EPSON Status Monitor 2 when using
IntranetWare Client for NT in Windows NT 3.51/4.0, a message
reading "Could not complete Setup because EPSON Status Monitor
2 is running. Quit EPSON Status Monitor 2 and run Setup again"
may appear, and uninstall processing may terminate. In this case,
delete the following files from the directory where EPSON Status
Monitor 2 is installed, and then delete EPSON Status Monitor 2.
Deleting these files will not cause errors in the operation of Novell
IntranetWare Client for NT.
Files: NETWIN16.DLL, CLNWIN16.DLL, LOCWIN16.DLL,
NCPWIN16.DLL, NWIPXSPX.DLL, CLXWIN16.DLL,
CALWIN16.DLL

From Windows 95, 98, and NT 4.0

1. Close EPSON Status Monitor 2 as described in "Stopping
Monitoring" on page 11-26.
11-28 EPSON Status Monitor 2 (Windows Only)