Enable Stp - D-Link DES-3010G Command Line Interface Reference Manual

DES-3010F / DES-3010G / DES-3018 / DES-3026 Layer 2 Switch CLI Reference Manual
config stp ports
Restrictions
Example usage:
To configure STP with path cost 19, priority 15, and state enabled for ports 1-5.
DES-3026:4#config stp ports 1-5 cost 19 priority 15 state enabled
Command: config stp ports 1-5 cost 19 priority 15 state enabled
Success.
DES-3026:4#

enable stp

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable STP, globally, on the Switch:
received it automatically loses edge port status. false indicates that
the port does not have edge port status.
p2p [true | false | auto] – true indicates a point-to-point (P2P) shared
link. P2P ports are similar to edge ports however they are restricted
in that a P2P port must operate in full-duplex. Like edge ports, P2P
ports transition to a forwarding state rapidly thus benefiting from
RSTP. A p2p value of false indicates that the port cannot have p2p
status. auto allows the port to have p2p status whenever possible
and operate as if the p2p status were true. If the port cannot
maintain this status (for example if the port is forced to half-duplex
operation) the p2p status changes to operate as if the p2p value
were false.
state [enabled | disabled] − Allows STP to be enabled or disabled for
the ports specified in the port list. The default is disabled.
Only administrator-level users can issue this command.
Used to globally enable STP on the Switch.
enable stp
This command allows the Spanning Tree Protocol to be globally
enabled on the Switch.
None.
Only administrator-level users can issue this command.
DES-3026:4#enable stp
Command: enable stp
Success.
DES-3026:4#
63