To Enable Autoconfiguration On The Switch - D-Link DES-3010F Command Line Interface Reference Manual

When autoconfig is enabled and the Switch is rebooted, the normal login screen will appear for a few moments while the
autoconfig request (i.e. download configuration) is initiated. The console will then display the configuration parameters as they
are loaded from the configuration file specified in the DHCP or TFTP server. This is exactly the same as using a download
configuration command. After the entire Switch configuration is loaded, the Switch will automatically "logout" the server. The
configuration settings will be saved automatically and become the active configuration.
Upon booting up the autoconfig process is initiated, the console screen will appear similar to the example below. The
configuration settings will be loaded in normal order.
Example usage:

To enable autoconfiguration on the Switch:

DES-3026:4#enable autoconfig
Command: enable autoconfig
Success.
DES-3026:4#
Copyright(C) 2004-2007 D-Link Corporation. All rights reserved.
DES-3026:4#download configuration 10.41.44.44 c:\cfg\setting.txt
Command: download configuration 10.41.44.44 c:\cfg\setting.txt
Connecting to server................... Done.
Download configuration................. Done.
DES-3026:4#
The very end of the autoconfig process including the logout appears like this:
DES-3026:4#
DES-3026:4#
DES-3026:4##-------------------------------------------------------------------
DES-3026:4#
DES-3026:4#
DES-3026:4#
DES-3026:4#---------------------------------------------------------------------
DES-30XX Layer 2 Switch CLI Reference Manual
DES-3026 Fast Ethernet Switch Command Line Interface
Firmware: Build 2.00.020
End of configuration file for DES-3026
55