Advertisement
Available languages
Available languages
Rechargeable Battery Pack
This long life battery pack must be recharged when it fails to produce sufficient power on jobs
which were easily done before. At the end of its technical life, discard it with due care for our
environment:
•
Run the battery pack down completely, then remove it from the tool.
•
Li‑Ion cells are recyclable. Take them to your dealer or a local recycling station. The
collected battery packs will be recycled or disposed of properly.
TROUBlE
Saw will not start
Saw makes unsatisfactory
cuts
XPS™ worklight is flashing
Machine vibrates
excessively
Does not make accurate
mitre cuts
Material pinches blade
Troubleshooting Guide
BE SURE TO FOLLOW SAFETY RULES AND INSTRUCTIONS
WhAT's WROng?
Battery not installed
Battery not charged
Brushes worn out
Dull blade
Blade mounted backwards
Gum or pitch on blade
Incorrect blade for work being done
Battery not charged
Saw not mounted securely to stand or work bench
Stand or bench on uneven floor
Damaged saw blade
Mitre scale not adjusted correctly
Blade is not square to fence
Blade is not perpendicular to table
Workpiece moving
Kerf plate worn or damaged
Cutting bowed material
WhAT TO DO
Install battery. Refer to Installing and Removing Battery Pack.
Charge battery. Refer to Charging Procedure.
Have brushes replaced by authorised service centre.
Replace blade. Refer to Changing or Installing a New Saw Blade.
Turn blade around. Refer to Changing or Installing a New Saw Blade.
Remove blade and clean with coarse steel wool and turpentine or household oven cleaner.
Change the blade type. Refer to Saw Blades under Optional Accessories.
Charge battery. Refer to Charging Procedure.
Tighten all mounting hardware. Refer to Bench Mounting.
Reposition on flat level surface. Refer to Familiarization.
Replace blade. Refer to Changing or Installing a New Saw Blade.
Check and adjust. Refer to Mitre Scale Adjustment under Adjustments.
Check and adjust. Refer to Mitre Scale Adjustment under Adjustments.
Check and adjust fence. Refer to Bevel Square to Table Adjustment under Adjustments.
Clamp workpiece securely to fence or glue 120 grit sandpaper to fence with rubber cement.
Take to authorised service centre.
Refer to Bowed Material under Special Cuts.
English
15
Advertisement
