Advertisement
B. Position Control
The position of the P-IN-P picture and the Square Wipe picture can be changed on the monitor screen using this function.
@ Square Wipe picture
Reset the operation panel to initial mode.
Press the Square Wipe Button.
Press the one of the A-bus Selection
Buttons.
Press the one of the B-bus Selection
Buttons.
Slide the Mix/Wipe Control to have
Square Wipe picture.
Press the SELECT button.
The LED on the POSITION side should light.
Operate the Joystick Control.
Mi P-IN-P picture
Reset the operation panel to initial mode.
MIX WIPE EFFECT/FADE CONTROL
1
2
-24-
Slide the Mix/Wipe Control fully to the
B-bus position.
Press the SOURCE 1 button on the A-
bus Selection Buttons.
Press the SOURCE 2 bution on the B-
bus Selection Buttons.
Press the P-IN-P/EDGE button.
Press the SELECT button.
The LED on the POSITION side should light.
Operate the Joystick Control.
Notes:
1. In Double
Picture-In-Picture
mode,
the position
control operates in the vertical direction only.
2. The status of Colour Correction
is stored
in the
memory, while the position control is being oper-
ated. Refer to A. Colour Correction.
Advertisement
