Canon Arizona 6100 XTHF Mark II Series User Manual page 67

When an image is out of bounds in the actual table area, that area in the table preview is marked
in red.
When an image is out of bounds in the bleed region, that area of the table preview is marked in
yellow.
8) Inactive Print Job List
Inactive job list consists of a table and job count summary on top. A job count summary displays
the total number of inactive jobs. The list can be sorted by clicking on the appropriate column
header. The icons in the first column reflect the job type and status and can be use to sort the list.
The size column is sorted by image area. Date column is sorted by a compound value of date and
time. The inactive job list has the following features:
• The operator can drag and drop jobs to move them between the active and inactive job lists.
• Jobs deleted from the inactive list are deleted from the hard drive.
• The operator can automatically set the status of a job to Hold when the job is put in this queue.
This can be set separately for flatbed and roll media jobs.
9) Job information and parameters panel
The job information area displays only relevant job parameters of the current print job. Some of
the parameters may be modified.
Offsets
To change parameter values, click on the field and this brings up an onscreen
keyboard so you can click on the numbers required. It can also be changed
with the mouse wheel when the mouse cursor is positioned over the field. Ro-
tate the mouse wheel up or down increments or decrements offset at the rate
of one unit per notch. Hold the right mouse button and rotate the wheel incre-
ments or decrements at the rate of 10 units per notch. You can also use Pre-
view to drag an image to the desired position.
Position on media - No:
• Horizontal distance
• Vertical distance
Position on media - Yes:
• Media horizontal distance - Enter the horizontal distance of the media
• Media vertical distance - Enter the vertical distance of the media
• Media width - Enter the media width (default = Image width + Media hori-
zontal distance)
• Media height - Enter the media height (default = Image height + Media ver-
tical distance)
• Image alignment on media - The offset values for the image on the media
• Horizontal distance
• Vertical distance
Print Parame‐ Displays information about the print job that is currently selected:
ters • Print Mode - Print modes are selected in THRIVE. See "Print Modes Availa-
ble" below for details of each mode.
• Direction - Bidirectional and Forward or Reverse unidirectional printing.
• Overprints - If the Overprint count is set to greater than 0 (zero), the printer
will re-print the image again, that many times, on the same piece of media.
Chapter 3 - How to Navigate the User Interface
Print Job Control Module
4
67