Region Writing - Pioneer SC-99 Service Manual

1
Precautions
Files are stored in Root of USB memory.
Files are read from Root of USB memory.
A
 To make operations such as moving files, be sure to assign the saved file in Root
of the USB memory.
Also please be careful not to assign *.avr in multiple numbers.
The time and date of updating for saved file is fixed to "2006/03/08 20:01."
In principle, please implement Load without making of factory default settings.
Depending on the type of USB memory device, the setting file may not have properly been saved even though
[COMPLETE] is displayed after a SAVE process.
Before replacing the DIGITAL MAIN ASSY, perform a LOAD process and check that [COMPLETE] is displayed.
[Cautions]
You cannot use the backup function with USB memory until the Network Module software starts.
B
It takes about 60 seconds before the Network Module software starts.

8.3 REGION WRITING

This is the function to write Region information by using an USB Memory.
Automatic start-up is conducted with POWER ON if the Region information is not written.
This work is carried out when DISPLAY ASSY is replaced.
[Preparations]
1. Please copy the REGION File for the same model number and the point of destination with the object set to the route
directory of USB Memory.
C
Note: Copy only the REGION File to the USB memory. Never copy to other files.
[Precautions]
Please be sure to use the REGION File for the same model number and the point of destination with the object set.
If you make a mistake, it is impossible to rewrite. (Replacement of DISPLAY ASSY is required again)
Key operation
Plug in the AC cord.
(No Region information)
D
Power On (Automatically)
Start up finished
Function initial display
Connect USB
Memory.
Loading finished
correctly
Region Writing finished
E
[Cautions]
Writing of destination is not completed until the Network Module software starts.
It takes about 60 seconds before the Network Module software starts.
F
70
1
2
FL display
P O W E R O N
S E T R E G I O N
S C - 9 9 / C U X J
S C - 9 7 / C U X J
S C - L X 8 9 / S Y X J 8
S C - L X 7 9 / S Y X J 8
SC-99
2
3
[Procedures]
1. Connect an AC cord after replacing DISPLAY
ASSY. (Power turns ON automatically)
2. [SET REGION] is displayed several seconds after
[POWER ON] is displayed on the front panel.
(Standby status for REGION File writing)
3. Automatic writing starts when USB memory
prepared by [Preparation: 1] is inserted.
(Degree of several seconds)
4. The written model number is displayed after the
normal completion of REGION File writing.
(14 characters, maximum)
5. Pull out the AC cord.
3
4
4