Yamaha 02R96 Owner's Manual page 172

172
Chapter 16—Automix
At the point at which recording is stopped, the fader
returns to the position specified by the existing fader
data, at the speed specified by the Time parameter on
the Fader Edit pages.
TO END is OFF
At the point at which recording is stopped, the fader
returns to the position specified by the existing fader
data, at the speed specified by the Time parameter,
and all subsequent events are erased so that the fader
remains at that position right through to the end of
the Automix.
TO END is ON
EDIT OUT: These buttons are used to set the Edit Out mode: Off, Takeover, or Return. The
Edit Out mode determines how rerecorded fader moves align with existing fader data at the
punch out point. Fader data includes Input Channel levels, Bus Out master levels, Aux Send
master levels, the Stereo Out level, User Defined Remote Layer faders, and Group master
levels. The Edit Out modes are explained in the following table. The Return Time is speci-
fied on the Fader Edit page (see page 176).
Off
At the punch out point, the fader
remains at the same position until the
next Fader event in the existing data
occurs.
Existing data
Fader edit
Punch in Punch out
02R96 Version 2—Owner's Manual
Return
Existing data
Return time
Fader edit
Time
Punch in Stop recording
Existing data
Return time
Fader edit
Time
Punch in Stop recording
Return
At the punch out point, the fader returns
to the position specified by the existing
fader data, at the speed specified by the
Time parameter on the Fader Edit pages.
Existing data
Fader edit
Time
Punch in
Takeover or Off
At the point at which recording is stopped, the fader
remains at the same position until the next Fader
event in the existing data occurs.
Existing data
Punch in
At the point at which recording is stopped, all subse-
quent events are erased so that the fader remains at
that position right through to the end of the Automix.
Existing data
Punch in
At the punch out point, recording con-
tinues until the fader position intersects
the existing fader data. If you are still
touching the fader knob at the actual
punch out point, the fader is disabled
until you release it.
Return time
Time
Punch out Punch in
In this example, punch out was per-
formed by pressing the [AUTO] button,
and the fader was moved manually
between the punch out and actual
punch out points.
Fader edit
Time
Stop recording
Fader edit
Time
Stop recording
Takeover
Existing data
Fader edit
Time
Punch out
Actual punch out