Siemens SINUMERIK 840D sl Equipment Manual page 128

Commissioning
8.2 HMI-Advanced
Traversing keys
As standard, keys for axes 1 to 6 are displayed. If the 2nd vertical softkey is pressed in the CPF
menu (change over traversing keys), then the next time that the traversing keys are displayed,
keys 7 to 12 are displayed; after pressing the 2nd vertical softkey in the CPF menu, then axis keys
1 to 6 are displayed again, etc.
Note
Switch off CPF menu
The CPF_Disabled entry is evaluated in the [CONTROL] section of the MMC.INI configuration
file: If the value = 1, the CPF menu will not be displayed.
128
Handheld Terminal HT 8
Equipment Manual, 02/2024, A5E52918633B AA