Husqvarna DXR 95 Operator's Manual page 95

9. Put a container (C) below the drain plug for the
hydraulic oil.
D
10. Remove the drain plug (D) for the hydraulic oil and
clean it.
11. Let the hydraulic oil drain into the container.
12. Replace the hydraulic oil filter if it is necessary. Refer
To replace the hydraulic oil filter (DXR 95) on
to
page 100 .
13. Install the drain plug for the hydraulic oil and tighten
it.
14. Install the air filter and tighten it.
15. Install the front cover and tighten the 4 bolts.
CAUTION:
when the hydraulic oil tank is empty. The
hydraulic pump will become damaged.
Fill the hydraulic oil tank with hydraulic
oil. Refer to
95) on page 97 .
To drain the hydraulic oil (DXR 145)
WARNING:
hydraulic oil becomes hot during operation
of the product. Let the product become cool
before you drain the hydraulic oil.
WARNING:
equipment when you drain the hydraulic oil.
Personal protective equipment on
Refer to
page 25 .
1. Park the product on level ground.
1401 - 005 - 11.01.2024
C
Do not start the product
To fill the hydraulic oil (DXR
Risk of burn injury. The
Use personal protective
2. Turn the arm system 90° to one side of the product.
3. Fully retract the arm system.
4. Fully retract the front outriggers. Keep the rear
outriggers extended. Refer to
outriggers on page 83 .
5. Stop the product. Refer to
145) on page 83 .
6. Remove the 4 screws and the front cover.
7. Clean the area around the air filter.
8. Remove the air filter to release the pressure in the
hydraulic oil tank.
9. Put a container below the drain plug for the hydraulic
oil.
To operate the
To stop the product (DXR
95