Husqvarna DXR 95 Operator's Manual page 101

5. Remove the air filter to release the pressure in the
hydraulic oil tank.
6. Clean the hydraulic oil filter cover (C) and the
adjacent parts.
7. Remove the hydraulic oil filter cover together with
the sealing ring (D) and the spring (E).
8. Examine the sealing ring for damage. Replace the
sealing ring if it is necessary.
9. Remove the filter holder (F).
10. Remove the hydraulic oil filter (G) from the filter
holder.
11. Examine the filter holder for unwanted materials
or particles. Unwanted materials or particles shows
damage or contamination of the hydraulic system.
1401 - 005 - 11.01.2024
C
D
E
G
F
12. Clean the filter holder with a degreaser and flush
the filter holder with warm water. Dry the filter holder
with compressed air.
13. Install a new hydraulic oil filter in the filter holder.
14. Install the filter holder in the hydraulic oil tank.
15. Install the hydraulic oil filter cover.
16. Install the air filter.
17. Install the front cover and tighten the 4 bolts.
To replace the hydraulic oil filter (DXR
145)
WARNING:
hydraulic oil becomes hot during operation
of the product. Let the product become cool
before you replace the hydraulic oil filter.
WARNING:
equipment when you fill the hydraulic oil.
Personal protective equipment on
Refer to
page 25 .
1. Park the product on level ground.
2. Stop the product. Refer to
145) on page 83 .
3. Remove the 4 screws and the front cover.
4. Clean the area around the air filter.
Risk of burn injury. The
Use personal protective
To stop the product (DXR
101