After you finish
1. Complete the parts replacement. See
2. Access the Lenovo XClarity Controller; then, select Network in BMC Configuration and enable
Ethernet Port 2.
MicroSD card replacement
Follow the instructions in this section to remove and install the MicroSD card.
•
"Remove the MicroSD card" on page 159
•
"Install the MicroSD card" on page 160
Remove the MicroSD card
Follow the instructions in this section to remove the MicroSD card.
About this task
Attention:
• Read
"Installation Guidelines" on page 47
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
"Power off the server" on page
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
Procedure
Step 1.
Prepare your server.
a.
Remove the top cover. See
b.
If your server comes with riser assemblies, remove them first, see
assembly" on page
c.
If your server comes with a rear drive assembly, remove it first. See
drive cage replacement" on page
d.
If your server comes with a 7mm rear drive assembly, remove it first. See
drive cage" on page
e.
Record where the cables are connected to the system board assembly; then, disconnect all
the cables.
Attention: Disengage all latches, cable clips, release tabs, or locks on cable connectors
beforehand. Failing to release them before removing the cables will damage the cable
connectors on the system board assembly. Any damage to the cable connectors may require
replacing the system board assembly.
Step 2.
Remove the MicroSD card.
"Complete the parts replacement" on page
and
"Safety inspection checklist" on page 48
62.
"Remove the top cover" on page
232.
213.
205.
279.
277.
"Remove a rear riser
"Rear drive backplane and
"Remove the 7mm
.
Chapter 5
Hardware replacement procedures
to ensure that you
159