Sony DTC-670 Operating Instructions Manual page 8

el=Yal thi lale Mm ac:latcw-ltlem Oce)altge) i)
This section describes the names and functions of each parts of this unit. Before operating this unit, please read carefully.
Front Panel/Remote Commander
[1] POWER switch
Turns the power on and off.
[2] Cassette compartment
Insert a cassette with the window side up and the safety
tab facing you.
(3) Display window
[4] END ID buttons
WRITE: Press to write the ID signifying the end of
playback or recording.
ERASE: Press to erase the end ID.
SKIP ID buttons
WRITE: Press at the beginning of the portion you may
wish to skip later. A skip ID will be written from the
point where you pressed this button.
ERASE: Press to erase the nearest skip ID which is
before the current position.
[6] START ID buttons
AUTO: Press to turn on and off the AUTO indicator.
When the AUTO indicator is lit, the start 1D will
automatically be written during recording. When the
AUTO indicator is not lit, press the START ID WRITE
button at the point where you want to write a start ID.
WRITE: Press to write the start [D at the desired point
during recording or playback.
ERASE: Press to erase a start ID, When a start 1D and
a program number are written on the tape, both
codes are simultaneously erased by pressing this
button.
RENUMBER: Press to renumber all programs on the
tape. When only the start IDs are written, pressing
this button will insert the proper program numbers
beginning with "1". The tape will rewind and start
from the beginning to accomplish this function.
INPUT selector
Set according to the signal to be recorded.
ANALOG: For recording from the equipment
connected to the LINE IN jacks.
OPTICAL: For recording from the equipment
connected to the DIGITAL IN (OPTICAL) jack.
COAXIAL: For recording from the equipment
connected to the DIGITAL IN (COAXIAL) jack.
REC LEVEL (recording level) control
Adjust the recording level for the analog input signals.
When recording digital signals, it is not necessary to
adjust the recording level.