Sony DTC-670 Operating Instructions Manual page 39

Search function does not
operate during playback.
The start ID is not written correctly. Erase it (page 23), and then write it
again.
The portion between the end of a start ID
and the beginning of the following start
ID is less than 9 seconds (18 seconds in
[the long-play mode) long.
+
When writing the start IDs manually, write
so that the intervals between them are
more than 9 seconds (18 seconds in the
long-play mode.)
mee
The selected program number does not
jen on the tape.
The program numbers are out of order.
Use the RENUMBER button to re-arrange
the program numbers. (page 25)
Search function operates
suddenly during playback.
The skip play function is operating.
(The SKIP PLAY indicator lights in the
display window.)
Turn off the indicator by pressing SKIP
PLAY.
REPEAT 1/ALL.
Search function stops.
e
There is a blank section between
selections. (The sampling frequency
indicator blinks on the display window.)
L
i: he repeat play function is operating. Pps off the indicator by pressing
Use the end search function (page 18)
when recording so that no blank is
created.
The tape operation buttons do
not operate while writing the
start ID.
be written.
playback.
The absolute time codes cannot
End ID cannot be written during
While writing the start ID (9 seconds or
18 seconds), none of the buttons except
the @ and OPEN/CLOSE buttons
operate.
Recording was started from the blank
section.
[point
Operate after the start ID is written.
Rewind the tape to the beginning, or
locate the very last point of the previous
recording, using the end search function
(page 18), and start recording from the
The portion where you want to write the
ex ID is blank.
Set the deck in the record-pause mode
by pressing REC, then write the end ID.
operate.
Renumbering function does not
The portion between the end of a start ID
and the beginning of the following start
Start ID cannot be erased.
ID is less than 9 seconds (18 seconds in
the long-play mode) long.
|!ong-play mode).
When writing the start IDs manually, write
so that the intervals between them are
more than 9 seconds (18 seconds in the
Skip ID cannot be erased.
}-
Two skip IDs are written continuously.
L
When writing the skip IDs, write so that
the intervals between them are more than
1 second (2 seconds in the long-play
mode).
End ID cannot be erased. The end ID is written at the beginning of
the tape.
Start recording from the beginning of the
tape.
The end ID is written immediately after a
start ID.
ie
First erase the start ID.
39