Sony DTC-670 Operating Instructions Manual page 28

Make sure that the safety tab of the cassette is at the
record-possible position.
1 Search for the beginning of the end ID with the p>
button. (See page 18.)
When the end ID is detected, the "EE" indicator lights.
2 Press the END ID ERASE button.
The END ID ERASE indicator lights while the end ID is
being searched for and then goes off when the end ID is
erased.
If you want to start recording from the point where the end
IDis written, you need not press the END ID ERASE button.
[~ ID |
SKIP iO
nase]
7
28
Playback
This section describes about a basic playback operation.
Playing back
1 Make sure that the TIMER switch is set to the OFF
position, and then turn on the power.
2 insert the cassette and press the OPEN/CLOSE
button to load the cassette.
3 Press the & (play) button.
Playback begins.
If an end ID is written on the tape, playback stops
automatically at the end ID position, and the tape will be
rewound to the beginning.
Press the PAUSE or >»
button.
Press the 2OPEN/
CLOSE button.
Stop the tape and press
the <4 or »® button.
Cue/review operation
1G] Press the p>
button during
playback.
Sound is heard while |
the button is
pressed. Release
the button at the
desired point.
Playback resumes.
Press the <<
button during
playback.
The speed of the tape increases about 4 seconds after the
cue or review starts.